TM 5-5420-280-23&P
0039 00
PALLET SUPPORTING CYLINDER WINCH AND STRAP REPLACEMENT (Contd)
NOTE
Removal and installation of right and left pallet supporting
cylinder winch and strap are performed the same way. Right side is
shown.
REMOVAL
1.
Remove screw (9) and lanyard (10) with retainer pin (16) from bracket (8) on pallet frame
member (22).
2.
Remove screw (17), washers (18) and (19), pin (21), and winch strap (1) from cylinder bracket (20).
3.
Remove two snaprings (13), pin (12), and connecting link (11) from eye (14).
NOTE
Note position of locking pin for installation.
4.
If damaged or bent, remove locking pin (15) from connecting link (11).
5.
Remove four screws (4), washers (5), and winch (6) with winch strap (1) from bracket (8).
6.
Unwind winch strap (1) and remove three screws (3), plate (2), and winch strap (1) from winch
drum (7).
NOTE
If clutch drive is slipping, disassemble, clean and check for
damaged clutch disks. Do not oil clutch disks. Replace winch
assembly if damaged.
7.
If damaged, remove two screws (29) and clutch drive adapter (30) from crank base (26).
8.
Remove nut (28), washer (27), clutch disk (25), ratchet wheel (24), and clutch disk (23) from winch
drum shaft (31). Clean clutch disks (25) and (23).
INSTALLATION
1. If removed, install cleaned clutch disk (23), ratcher wheel (24), cleaned clutch disk (25), and crank
base (26) on winch drum shaft (31) with washer (27) and nut (28).
2.
Install clutch drive adapter (30) on crank base (26) with two screws (29).
3.
Install winch strap (1) on winch drum (7) with plate (2) and three screws (3).
NOTE
Ensure that all mounting hardware is tightened to metric
standards unless otherwise noted. Refer to metric torque limits in
4.
Install winch (6) on bracket (8) with four washers (5) and screws (4).
5.
If removed, install locking pin (15) on connecting link (11).
6.
Install connecting link (11) on eye (14) with pin (12) and two snaprings (13).
7.
Install winch strap (1) on cylinder bracket (20) with pin (21), washers (19) and (18), and screw (17).
8.
Install lanyard (10) with retainer pin (16) on bracket (8) with screw (9).
9.
Lift supporting cylinders to stow position. Refer to TM 5-5420-280-10.
0039 00-2
