TM 5-5420-280-23&P
0059 00
WINCH STOWAGE DRUM ROPE INLET COVER AND GUIDE ROLLERS REPLACEMENT (Contd)
REMOVAL
1. Loosen jamnut (17) and screw (16) on rope guide bracket (2).
2. Remove screw (5), washer (6), and stowage drum rope inlet cover (7) from axle drive motor (10), and
slide rope guide bracket (2) off rope track end (1).
NOTE
Perform steps 3 and 4 if replacing rope inlet cover.
3. Remove seven nuts (14), screws (4), and guide rollers (3) from bracket (1) on inlet cover (7).
4. Remove two nuts (8), screws (13), washers (12), and rollers (9) from bracket (15).
INSTALLATION
NOTE
Apply a light coat of sealing compound to threads of all screws at
installation. Apply a light coat of grease to inside of rollers at
installation.
1. Install two rollers (9) on bracket (15) with two washers (12), screws (13), and nuts (8).
2. Install seven guide rollers (3) on bracket (15) with seven screws (4) and nuts (13).
3. Slide rope inlet bracket (2) on end of rope track (1), and install rope inlet cover (7) on stowage
drum (11) and axle drive motor (10) with washer (6) and screw (5).
4. Tighten screw (16) and jamnut (17) on rope inlet bracket (2).
5. Pay wire rope through guide rollers into stowage drum. Refer to WP 0057 00.
4
3
1
5
2
6
7
17
8
16
15
14
9
13
12
10
11
END OF WORK PACKAGE
0059 00-2