TM 5-5420-280-23&P
0061 00
WINCH STOWAGE DRUM, MOUNTING BRACKET, AND AXLE UNIT REPLACEMENT (Contd)
REMOVAL
CAUTION
Cap or plug all hoses, connections, and openings immediately after
disconnection to prevent contamination. Remove caps or plugs prior
to installation. Failure to do so may result in damage to equipment.
NOTE
Have container ready to catch oil.
1. Disconnect hydraulic tube (10) from elbow (9).
2. Disconnect elbow (9) from adapter (8) on axle unit (5).
3. Remove adapter (8) from axle unit (5).
4. Remove six screws (7), washers (6), and stowage drum assembly (4) from mounting bracket (13).
5. Remove six screws (2), washers (3), and axle unit (5) from stowage drum (4).
6. Remove four locknuts (11), lockwashers (12), washers (13), screws (15), and mounting bracket (14)
from winch frame (1). Discard locknuts (11) and lockwashers (12).
INSTALLATION
NOTE
Ensure that all mounting hardware is tightened to metric
standards unless otherwise noted. Refer to metric torque limits in
1. Install mounting bracket (14) on winch frame (1) with four screws (15), washers (13), new
lockwashers (12), and locknuts (11).
NOTE
Apply a light coat of sealing compound to all threads of screws at
installation.
2. Install axle unit (5) on stowage drum (4) with six washers (3) and screws (2). Tighten screws (2) to
11 lb-ft (15 Nm).
3. Install stowage drum assembly (4) on mounting bracket (13) with six washers (6) and screws (7).
Tighten screws (7) to 24 lb-ft (32 Nm).
NOTE
Apply a light coat of sealant to threads of adapter at installation.
4.
Install adapter (8) on axle unit (5).
5.
Connect elbow (9) to adapter (8).
NOTE
The pallet hydraulic system is self-bleeding, and with exception of
the telescopic tube hydraulic cylinders, there is no requirement for
bleeding air from the system.
6. Connect hydraulic tube (10) to elbow (9).
7. Install winch stowage rope inlet cover. Refer to WP 0059 00.
0061 00-2