HEATING AND AIR CONDITIONING SYSTEM FRONT COVER

INSTALL PERSONNEL SHELTER SHORE TIE MALE ELECTRICAL CONNECTOR - TM-55-1945-205-24-2_301

HEATING AND AIR CONDITIONING SYSTEM INDOOR AIR FILTER - TM-55-1945-205-24-2_305

TM-55-1945-205-24-2 Modular Causeway System (MCS) Roll-On/Roll-Off Discharge Facility Model (RRDF) RRDF-1 NSN 1945-01-473-2282 Manual
Page Navigation
236

TM 55-1945-205-24-2 0099 00 1/2 blank 0099 00 UNIT LEVEL MAINTENANCE ROLL-ON/ROLL-OFF DISCHARGE FACILITY HEATING AND AIR CONDITIONING SYSTEM FRONT COVER REMOVAL AND INSTALLATION INITIAL SETUP: Personnel Required Engineer 88L REMOVE HEATING AND AIR CONDITIONING SYSTEM FRONT COVER 1. Verify air conditioning switch is in the off position. 2. Grasp front cover (1) firmly near the top of each side. NOTE It is not necessary to use excessive force when removing the front cover. 3. Lift upward and pull outward to remove front cover (1) from heating and air conditioning unit (2). INSTALL HEATING AND AIR CONDITIONING SYSTEM FRONT COVER 1. Grasp front cover (1) firmly near the top of each side. NOTE It is not necessary to use excessive force when installing the front cover. 2. Align front cover (1) with the bottom mounting edge of the heating and air conditioning unit (2) and push inward until cover snaps into place. END OF WORK PACKAGE 1 2

Privacy Statement
Press Release
Contact