TM 55-1945-205-24-2
0133 00 4
0133 00
INSTALL VHF/FM HANDHELD TRANSCEIVER BATTERY CHARGER POWER SUPPLY
1.
Remove four small screws (22) from four rubber foot pads (23) on new DC power supply box (17). Discard four
small screws (22).
2.
Remove four screws (9) from new power supply cover (10).
3.
Remove new power supply cover (10).
4.
On new power supply box (17), use a drill and 3/16 drill bit to enlarge holes where the four small screws (22)
were removed.
5.
Position new DC power supply box (17) under mounting plate (18).
6.
Firmly hold the DC power supply box (17) while installing it under mounting plate (18).
7.
Install four screws (21) through mounting plate (18), rubber foot pads (23) and new DC power supply box (17).
Tighten four screws (21).
8.
Install four washers (20) and lock nuts (19) on four screws (21). Tighten lock nuts (19).
9.
Rotate terminal box (12) 90°.
10. Install four lock washers (15) and screws (14) on terminal strip (16). Tighten screws (14).
11. Position terminal box cover (13) over terminal box (12).
12. Install four screws (11) through terminal box cover (13) and into terminal box (12). Tighten four screws (11).
13. Position power supply cover (10) on power supply box (17).
14. Install four screws (9) through power supply cover (10). Tighten four screws (9).
15. Push rubber packing (7) into nylon stuffing tube (8).
16. Install retaining nut (6) on nylon stuffing tube (8). Tighten retaining nut (6).
17. Connect wires (5) and tighten two plastic nuts (4).
18. Plug power cord (2) into AC outlet (3).
19. Position DC power supply switch (1) to the on position.
20. Perform operational check of VHF/FM handheld transceiver battery charger power supply.
(TM 55-1945-205-10-2)
END OF WORK PACKAGE
22
23
17