TM 55-1945-205-24-2
0272 00 2
0272 00
a.
If not previously done, loosen screw (2) on cable retainer (3).
b.
Rotate propeller (4) and move throttle and shift control lever from NEUTRAL to FORWARD then halfway
back to NEUTRAL. (TM 55-1945-205-10-2)
c.
On side of engine, move throttle lever (5) firmly against idle stop screw (6).
d.
Position throttle control cable (1) on throttle lever pin (7) and secure with washer (8) and lock nut (9). Tighten
lock nut (9).
e.
Firmly pull on throttle control cable (1) to remove backlash.
f.
Tighten screw (2) on the cable retainer (3).
2.
Adjust shift control cable (10).
a.
If not previously done, loosen screw (11) on cable retainer (3).
b.
Rotate propeller and verify throttle and shift control lever is FORWARD.
c.
Position shift control cable (10) on shift lever pin (12) and loosely install flat washer (13) and lock nut (14).
d.
Firmly pull on shift control cable (10) to remove backlash.
e.
Return the throttle and shift control lever to NEUTRAL. (TM 55-1945-205-10-2)
f.
Temporarily remove shift control cable (10) to verify gearcase is in neutral.
g.
Install shift control cable (10) and tighten lock nut (14).
h.
Tighten screw (11) on cable retainer (3).
3.
Install RHIB engine cover. (WP 0297 00)
4.
Install RHIB battery negative lead terminal. (WP 0336 00)
END OF WORK PACKAGE
10
3
11
12,13,14
