TM 55-1945-205-24-2
0271 00 4
0271 00
4.
Connect throttle shaft (20) to top carburetor shaft plate (21).
5.
While advancing throttle cam (17), embossed mark (18) on throttle cam (17) should align with center of cam
follower (16) as tip of throttle shaft (20) begins to move.
ADJUST THROTTLE CAM
1
Install throttle control cable. (WP 00283 00)
2.
Verify throttle arm (22) is firmly against idle stop (23).
3.
Hold throttle link coupler shell (14) on throttle cam ball (15) with light pressure.
4.
Rotate cam follower (16) and inspect/adjust clearance between cam follower (16) and throttle cam (17).
a.
Adjustment is correct if cam follower (16) does not touch throttle cam (17) and clearance is less than
0.010 in. (0.025 cm), adjustment is correct.
b.
If adjustment is not correct, turn throttle link coupler shell (14) further onto link to increase clearance.
c.
Turn throttle link coupler shell (14) away from link to decrease clearance.
d.
When proper clearance is achieved, snap throttle link coupler shell (14) on throttle cam ball (15).
5.
Test adjusted clearance by raising and lowering fast idle lever on throttle and shift control assembly.
(TM 55-1945-205-10-2)
6.
Verify throttle arm (22) is firmly against idle stop (23) and cam follower (16) to throttle cam (17) clearance is less
than 0.010 in. (0.025 cm).
14,15
16
17
23
22