TM 55-1945-205-24-2
0273 00 2
0273 00
3.
Remove two hex nuts (5) and external tooth lock washers (6) from gauge mounting studs (7).
4.
Remove trim/tilt gauge (8) from front of control console (9). Discard trim/tilt gauge (8).
INSTALL RIGID HULL INFLATABLE BOAT TRIM/TILT GAUGE
1.
Position new trim/tilt gauge (8) through hole in front of control console (9).
2.
Position gauge mounting bracket (10) over gauge mounting studs (7).
3.
Install two external tooth lock washers (6) and hex nuts (5) on gauge mounting studs (7). Tighten nuts (5).
4.
Install four electrical wires (1), external tooth lock washers (3) and hex nuts (2) on gauge electrical studs (4).
Tighten nuts (2).
5.
Remove tags from electrical wires (1).
6.
Install RHIB battery negative lead terminal. (WP 0336 00)
7.
Perform operational check of RHIB. (TM 55-1945-205-10-2)
END OF WORK PACKAGE