TM 5-5420-226-20-3
TM 5-5420-202-20-3
BASKET/CONTROL PANEL STARTING HARNESS REPLACEMENT (Sheet 3 of 5)
4.
Using 7/16 inch socket, remove top screw
(H), lockwasher (J), and washer (K) securing
strap (L) at three locations. Leave bottom
screw (M) installed.
5.
Using 7/16 inch socket, remove screws (N)
and lockwashers (P) securing clamps (Q) at
six locations.
6.
Using 7/16 inch socket, remove screw (R)
and lockwasher (S) securing clamp (T) at
vehicle floor and at handle (U) of purge
pump (V).
7.
Slip wiring harness (W) from behind
straps (L) and out of clamps (Q) and
(T) and remove from vehicle.
NOTE
The illustration below shows locations of harness
assembly supporting straps and clamps and the routing
of the harness assembly.
Go on to Sheet 4
10-295-.33
Change 6
6 31