• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
SHIFT LINKAGE ADJUSTMENT - Continued
SHIFT LINKAGE ADJUSTMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  524    525    526    527    528  529  530    531    532    533    534  
img
TM 5-5420-226-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 10 of 28)
44.
Using 9/16 inch wrench, adjust shifting rod
bearing end (AG) by turning clockwise or
counterclockwise until screw (AF) will drop
freely through clevis (AC) and shifting rod
bearing end (AG).
Using small diameter wire, check to see if
45.
shifting rod (AH) is past holes (AJ) and
(AK). If shifting rod (AH) is past holes
(AJ) and (AK), do steps 46 thru 48. If
shifting rod (AH) is not past hole (AJ),
do steps 49 thru 57. If shifting rod (AH)
is not past hole (AK), go on to step 58.
46.
Using 9/16 inch wrench, install screw (AF)
through clevis (AC) and shifting rod bearing
end (AG).
Holding rod bearing ends (AG) and (AL) with 9/16 inch wrench, use torque wrench and
47.
9/16 inch crow foot adapter to tighten jamnuts (AD) and (AE) to 16-18 lb-ft (22-24 N·m).
48.
Using torque wrench and 9/16 inch socket, tighten screw (AF) to 16-18 lb-ft (22-24 N·m)
and go on to step 68.
TA169063
Go on to Sheet 11
11-42






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.