TM 5-1940-322-24
0048 00
INTERMEDIATE WIRING HARNESS REPLACEMENT (Contd)
NOTE
Port and starboard intermediate wiring harnesses are replaced the
same way. This procedure covers the replacement of one
intermediate wiring harness.
Tag all connectors and electrical leads to assist with installation.
REMOVAL
1.
Disconnect intermediate wiring harness connector (3) from engine wiring harness connector (1).
2.
Remove three locknuts (7), screws (4), and clamps (5) holding intermediate wiring harness (6) to
battery compartment forward bulkhead (8). Discard locknuts (7).
3.
Remove tiedown straps (2) and intermediate wiring harness (6) from engine compartment, battery
compartment, starboard side of cockpit, and stowage compartment.
4.
Remove intermediate wiring harness (6) from stowage compartment and boat.
INSTALLATION
1.
Route intermediate wiring harness (6) from stowage compartment to starboard side of cockpit through
battery compartment to engine compartment.
2.
Install intermediate wiring harness (6) on battery compartment bulkhead (8) with three screws (4),
clamps (5), and new locknuts (7).
3.
Connect intermediate wiring harness connector (3) to engine wiring harness connector (1) with new
tiedown straps (2).
4.
5.
6.
Close battery hatch (TM 5-1940-322-10).
7.
Close engine hatches (TM 5-1940-322-10)
8.
0048 00-2