TM 5-1940-322-24
0119 00
TRANSMISSION OIL HOSES AND FITTINGS MAINTENANCE (Contd)
CAUTION
Cap or plug all hoses, connections, and openings immediately after
disconnection to prevent contamination. Remove caps or plugs prior
to installation. Failure to comply may result in damage to
equipment.
NOTE
The transmission oil cooler hoses on both engines are replaced the
same way. This procedure covers the replacement of two
transmission oil cooler hoses.
REMOVAL
NOTE
Note position of elbows to assist with installation.
Have container ready to catch transmission oil.
1.
Disconnect oil cooler hoses (2) and (5) from fittings (1), (4), and (6).
2.
Remove transmission oil pressure sending unit (WP 0124 00).
3.
Remove oil cooler fittings (1), (4), and (6) from transmission (3) and transmission oil cooler (7).
CLEANING AND INSPECTION
1.
For general cleaning and inspection instructions, refer to WP 0013 00.
WARNING
Skysol 100 solvent is combustible; DO NOT use or store near heat,
sparks, flame, or other ignition sources. Use mechanical ventilation
whenever product is used in a confined space, heated above
ambient temperatures, or agitated. Keep container sealed when
not in use.
Contact with Skysol 100 may cause skin irritation. Use chemical-
resistant gloves. In case of skin contact, remove any contaminated
clothing and wash skin thoroughly with soap and water. Wash
contaminated clothing before reuse. Eye contact may cause
irritation, tearing, or blurring of vision. Use face shield or goggles
when eye contact may occur. In case of eye contact, flush eyes with
large amounts of water for at least 15 minutes or until irritation
subsides. Inhalation may cause irritation to upper respiratory
passages. DO NOT have food or drink in the vicinity. Failure to
comply may result in injury to personnel.
2.
Remove excess sealant from fittings with Skysol 100 and dry with cloth.
INSTALLATION
1.
Apply thin coat of sealing compound to threads of all fittings.
2.
Install four oil cooler fittings (1), (4), and (6) on transmission (3) and transmission oil cooler (7).
3.
Install transmission oil pressure sending unit (WP 0124 00).
4.
Connect transmission oil cooler hoses (2) and (5) on fittings (1), (4), and (6).
5.
Fill transmission with oil (WP 0012 00).
6.
Start engine and check for leaks (TM 5-1940-322-10).
7.
Install aft cockpit (WP 0016 00).
8.
Close engine hatches (TM 5-1940-322-10).
0119 00-2
