TM 5-1940-322-24
0155 00
FRONT GEAR HOUSING COVER, CRANKSHAFT FRONT SEAL, AND FRONT GEAR HOUSING
MAINTENANCE (Contd)
WARNING
All personnel must stand clear during lifting operations. A
swinging or shifting load may cause injury to personnel.
Two personnel or a suitable lifting device is required for removal
and installation. Failure to comply may cause injury to personnel
and/or damage to equipment.
NOTE
The front seal, housing cover, and housing, on both engines are
replaced the same way. This procedure covers the replacement of
one front seal, housing cover, and housing.
Tag all electrical leads and hoses during removal to assist with
installation.
REMOVAL
1.
Remove sixteen screws (6), gear cover (1), and gasket (2) from gear housing (3). Discard gasket (2).
CAUTION
Use caution when positioning gear cover. Failure to comply may
result in damage to gear cover.
2.
Position gear cover (1) front-side down. Remove seal (8) from gear cover (1). Discard seal (8).
3.
Remove access cap (7) from gear cover (1).
4.
Remove vibration damper (WP 0111 00).
5.
Remove camshaft (WP 0158 00).
6.
Remove fuel injection pump (WP 0102 00).
7.
Remove four screws (11) and two screws (10) from gear housing (3) and cylinder block (9).
8.
Gently pry gear housing (3) and gasket (4) from cylinder block (9). Discard gasket (4).
CLEANING AND INSPECTION
1.
For general cleaning and inspection instructions, refer to WP 0013 00.
WARNING
Skysol 100 solvent is combustible; DO NOT use or store near heat,
sparks, flame, or other ignition sources. Use mechanical ventilation
whenever product is used in a confined space, heated above
ambient temperatures, or agitated. Keep container sealed when not
in use.
Contact with Skysol 100 may cause skin irritation. Use chemical-
resistant gloves. In case of skin contact, remove any contaminated
clothing and wash skin thoroughly with soap and water. Wash
contaminated clothing before reuse. Eye contact may cause
irritation, tearing, or blurring of vision. Use face shield or goggles
when eye contact may occur. In case of eye contact, flush eyes with
large amounts of water for at least 15 minutes or until irritation
subsides. Inhalation may cause irritation to upper respiratory
passages. DO NOT have food or drink in the vicinity. Failure to
comply may result in injury to personnel.
0155 00-2
