TM 5-1940-322-24
0155 00
FRONT GEAR HOUSING COVER, CRANKSHAFT FRONT SEAL, AND FRONT GEAR HOUSING
MAINTENANCE (Contd)
INSTALLATION
1.
Apply coat of gasket-forming compound on both sides of new gasket (4).
NOTE
Assistant will help with step 2 to support housing.
2.
Install new gasket (4) and gear housing (3) on engine (9) with four screws (11) and two screws (10).
Tighten screws (11) and (10) to 18 lb-ft (24 Nm).
3.
Install camshaft (WP 0158 00).
4.
Install fuel injection pump (WP 0102 00).
6.
Apply coat of gasket-forming compound on both sides of new gasket (2), gasket surfaces of gear
cover (1), and gear housing (3).
7.
Install new gasket (2) and gear cover (1) on gear housing (3) with sixteen screws (6). Do not tighten
screws (6).
CAUTION
The seal pilot is included in the front seal service kit. Always use a
seal pilot when installing the front seal. Failure to comply may
result in damage to equipment.
NOTE
The seal pilot is also used as an alignment tool.
8.
Using seal pilot, align gear cover (1) to crankshaft (5).
Tighten screws (6) to 18 lb-ft (24 Nm) and remove seal pilot.
9.
10.
Apply bead of sealing compound to outside diameter of seal (8).
11.
Using seal pilot, install seal (8) over crankshaft (5) and position in gear cover (1). Remove seal pilot.
12.
Using seal pilot and plastic hammer, drive seal (8) to correct depth by striking at 12, 3, 6, and 9 o'clock
positions.
13.
Install gear cover access cap (7) on gear cover (1).
14.
Install vibration damper (WP 0111 00).
15.
Install belt tensioner (WP 0087 00).
16.
Install drivebelt (WP 0086 00).
17.
Install belt guard (WP 0085 00)
18.
Install engine (WP 0115 00).
19.
Close engine hatches (TM 5-1940-322-10).
20.
Connect battery ground cables (WP 0054 00).
21.
Close battery hatch (TM 5-1940-322-10).
0155 00-4
