TM 5-5420-202-20-2
POWERPLANT REPLACEMENT (Sheet 13 of 21)
INSTALLATION:
Install six spring washers (A) (three each side)
1.
on transmission mounts.
2.
Make sure all surfaces in compartment are
clean. If not, clean engine compartment.
2.1
Install final drive adapter hook-up tool in final
drive adapter splines with opening pointed up
and slightly back (1 or 2 teeth from level
position).
3.
Apply light coat of grease to contact surfaces
of engine and transmission mounts.
NOTE
"T" end of sling should be toward front
(engine end of powerplant).
4.
Make sure hoist hook is in powerplant hole of
sling.
5.
Using hoist, pick up sling and install, four
chain hooks through four lifting eyes on
powerplant.
6.
Ends of chain hooks should point toward outer
side of powerplant.
Go on to Sheet 14
5-14
