TM
5-5420-202-20-2
TRANSMISSION OIL COOLER SCREEN REPLACEMENT (Sheet 1 of 2)
TOOLS:
1/2 in. socket with 1/2 in. drive
5 in. extension with 1/2 in. drive
1/2 in. combination box and open end wrench
3/4 in. combination box and open end wrench
PRELIMINARY
PROCEDURES:
Remove both air cleaner outlet hose assemblies (page 7-84)
NOTE
Left side-shown, right side similar.
REMOVAL:
NOTE
If removing 2A engine screen, go to step 6.
1.
Using socket, extension, and ratchet through
harness and into bracket, remove two
assembled washer screws (A).
NOTE
You will have bracket (B) and tube
(C) only if your vehicle is equipped
with a 2DA engine.
2.
Using socket and 1/2 inch wrench, remove
screw (D) and locknut (E) securing clamp
(F) and tube (C) to bracket (B).
3.
Using 3/4 inch wrench, remove bolt (G).
4.
Using socket, remove assembled washer screw
(H), screw (J), and washer (K) securing bracket
(B) and oil cooler screen (L).
Remove bracket (B) and oil cooler screen (L).
5.
For 2A engine; using socket, remove four
6.
screws (J) and four washers (K) securing oil
cooler screen (L). Remove oil cooler screen
(L).
Go on to Sheet 2
Change 1