TM 5-5420-202 -20-2
ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (Sheet 2 of 4)
REMOVAL:
1.
Using 9/16 inch wrench, remove vent
capscrew (A) and sealing washer (B).
2.
Throw away washer (B).
3.
Using 3/4 inch wrench loosen oil drain
valve (C) six complete turns.
4.
Using screwdriver and 3/8 inch wrench,
remove clamp (D) on hose (E) if clamp
is attached to hose. If clamp (D) is
not attached to hose (E), go to step
5.
5.
Using 1-1/2 inch wrench remove fitting
(F) from connector (G).
Using 1-1/2 inch wrench loosen fitting
6.
(H) and remove hose (E).
7.
Using 1/2 inch wrench, remove three
locknuts (J) from connector (G).
Discard three locknuts (J).
8.
Remove connector (G).
9.
Go on to Sheet 3
6-58