TM 5-5420-202-20-2
POWERPLANT LEFT BANK OIL COOLER FRAME AND BRACKETS REPLACEMENT (Sheet 2 of 9)
NOTE
Because of space limitations, it may be necessary to interchange
like size sockets and wrenches to get at a particular screw.
REMOVAL:
NOTE
It may be necessary to use screw-
driver and 3/8 inch wrench to remove
clamp (A) and move tube (B) before
fuel-water separator filter (C) can be
lowered.
1.
Using 1/2 inch socket, remove four cap-
screws, lockwashers, and flat washers (D).
Lower fuel-water separator filter (C) away
2.
from mounting bracket (E).
Using 5/8 inch socket, remove three screws,
3.
lockwashers and flatwashers (F) securing
mounting bracket (E) to engine. Remove
mounting bracket (E).
Using 1/2 inch socket, remove three assembled
4.
washer bolts (G).
Using 1/2 inch socket, remove screw and
5.
clamp (H).
Using 1/2 inch wrench, remove two screws (J).
6.
Remove ignition unit (K) with clamps
7.
and leads from frame.
Go on to Sheet 3
6-127