TM 5-5420-202-20-2
FUEL PUMP TO FUEL WATER SEPARATOR HOSE ASSEMBLY REPLACEMENT (Sheet 4 of 5)
INSTALLATION:
NOTE
Apply sealing compound to male pipe
threads before installation.
Install hose assembly (A) to elbow (B).
1.
Using 7/8 inch wrench, tighten
2.
nut (C) to elbow (B).
Using 7/8 inch wrench, install
3.
hose assembly (A) to fuel pump (D).
TEST:
Connect engine for powerplant ground
1.
hop (page 5-26).
Using 7/16 inch wrench, turn fuel-water
2.
separator bleed cap (A) to the left until
loose.
Go on to Sheet 5