TM 5-5420-202-20-2
FUEL TANK CONDENSATE REMOVAL (Sheet 2 of 6)
NOTE
Steps 2 and 3 apply to removal of dust covers from
hand fuel pump and hoses.
Using fingers in clamp rings (D), pull two
2.
clamps (E) out and down against body of
connector (F) to loosen dust cover (G).
Remove dust cover (G) from connector
3.
(F).
Install hose (H) on connector (F) on
4.
discharge side of hand fuel pump
(A).
5 . Using fingers in clamp rings (D), pull clamps (E)
out and up against hose (H) to clamp hose (H)
in place.
6. Repeat steps 4 and 5 for installing
hose on connector on suction side of
hand fuel pump (A).
Go on to Sheet 3
7-179