TM 5-5420-202-20-2
FUEL-WATER SEPARATOR FILTER ELEMENT REPLACEMENT (Sheet 3 of 6)
Do not remove or otherwise disturb
the center element (J) during outer
filter element (K) replacement unless
all three elements are scheduled for
replacement.
Using hands, remove two outer filter elements (K)
7.
by turning slightly and lifting out.
Remove center filter element (J) in same
8.
manner as outer filters, if required.
C L E A N I N G AND INSPECTION:
Dry cleaning solvent P-D-680 is toxic and flammable. To prevent personal injury, wear
protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100F (38C) and for Type #2 is 138F (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
NOTE
Exercise care when cleaning inside of
fuel-water separator not to damage
any internal parts.
1. Using dry cleaning solvent and cloth, clean
inside of fuel-water separator.
Inspect fuel-water separator for cracks.
2.
Inspect interior for scores and burrs.
3. Using dry cleaning solvent and crocus
cloth, remove minor burrs and scores.
If cracked, excessively burred, or scored,
contact your supervisor.
4. Flush with clean dry cleaning solvent.
INSTALLATION:
1. Remove container from under fuel-
water separators
Remove plastic barrier material and tape
2.
from fuel outlet line (A).
3. Using 7/8 inch wrench, install fuel
outlet line (A) to elbow (B).
Go on to Sheet 4