TM 5-5420-202-20-2
FUEL-WATER SEPARATOR FLUID PRESSURE FILTER ASSEMBLY REPLACEMENT (Sheet 4 of 7)
12. Using 1/2 inch socket and extension, remove
three capscrews, lockwashers, and washers (L).
13. Remove clamp (M) from filter (C).
NOTE
I t may be necessary
to use
hammer and punch to
unseat
sensors (Q and R) by
tapping
u p w a r d on the edge
of the
sensor retaining nut.
Using 1/2 inch socket and extension, loosen
14.
capscrew (N) to provide movement to fuel-
water separator filter (C).
Using 9/16 inch wrench, remove upper sensor (P)
15.
f r o m fuel-water separator filter (C).
Tag upper sensor (P) to make sure of correct
16.
installation.
17.
Using 9/16 inch wrench, remove lower sensor (Q)
f r o m fuel-water separator filter (C).
18.
Tag lower sensor (Q) to make sure of correct
installation.
Go on to Sheet 5
7-205