TM 5-5420-202-20-2
FUEL-WATER SEPARATOR FLUID PRESSURE FILTER ASSEMBLY REPLACEMENT (Sheet 7 of 7)
13.
Using lint-free cloth, wipe bottom of fuel-
water separator filter and connecting lines
clean of fuel.
14.
Remove drip pan.
TEST:
1.
Connect engine for powerplant ground hop (page
Using 1/2 inch wrench, open bleed valve (A).
2.
3.
Set FUEL PUMPS switch on master control
panel to ON (TM 5-5420-202-10).
4.
Set MASTER BATTERY switch on master
control panel to ON (TM 5-5420-202-10).
Watch bleed cap (A) of fuel-water separator
filter (B) for air release (bubbles).
5.
Set MASTER BATTERY switch to OFF
(TM 5-5420-202-10). When constant fuel
flow is seen, go to step 6.
6.
Using 1/2 inch wrench, turn fuel-water
separator bleed cap (A) clockwise until
snug.
7.
Check valve for leaks and tighten or replace components as necessary.
8.
Perform operational check of automatic drain (page 7-245).
Set FUEL PUMPS switch to OFF (TM 5-5420-202-10).
9.
10.
Set MASTER BATTERY switch to OFF (TM 5-5420-202-10).
11.
Disconnect engine from powerplant ground hop (page 5-40).
12.
Install powerplant (page 5-14).
End of Task
7-208