TM 5-5420-202-20-2
FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (Sheet 3 of 5)
12.
Using screwdriver, remove two screws
and two cushioned clamps (J) and mount-
ing plate (K) at right side and above
fuel-water separator control assembly (L)
NOTE
It may be necessary to use
pliers to start removal of con-
nectors in steps 13 and 14.
13. Manually disconnect engine electrical
harness connector (M) from fuel-water
separator control assembly (L) l
14. Manually disconnect solenoid valve
e l e c t r i c a l lead (N) from fuel-water
separator control assembly (L).
Using 5/16 inch wrench,
remove screw
15.
and cushioned clamp (P)
holding
solenoid valve electrical
lead (N)
t o fuel-water separator
control
assembly (L).
16.
Using 5/16 inch wrench, remove three
remaining screws and washers (Q)
h o l d i n g fuel-water separator control
assembly (L) to mounting plate.
Remove control assembly.
Go on to Sheet 4
7-211
