TM 5-5420-202-20-2
FUEL-WATER SEPARATOR DRAIN LINES REPLACEMENT (Sheet 1 of 6)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS: 11/16 in. combination box and open end wrench (2 required)
9/16 in. combinatoin box and open end wrench
1/2 in. combination box and open end wrench
5/8 in. combination box and open end wrench
6 in. adjustable wrench
Vise
Slip joint pliers
Drip pan
SUPPLIES:
Rags (Item 65, Appendix D)
Drip pan
Lockwasher
P R E L I M I N A R Y PROCEDURE: Remove powerplant (page 5-2)
NOTE
These procedures are given for the replacement of all
fuel-water separator drain lines. Only perform those steps
necessary to replace the defective part.
Go on to Sheet 2
