TM
5-5420-202-20-2
CAP ASSEMBLY REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
If bracket (A) was removed, position new bracket (A) onto engine. Using 1/2 inch socket,
1.
install two screws (B) to secure bracket (A).
2.
Position new gasket (C) and cap assembly
(D) to intermediate tube assembly (E).
3.
Using 7/16 inch socket, install screw (F)
and new lockwasher (G) to secure cap
assembly (D).
Using 1/2 inch socket, install screw (H)
4.
and new lockwasher (J) to secure cap
assembly (D).
5.
Install clamp (K) onto cap assembly (D).
6.
Using 1/2 inch socket and wrench, install
screw and new nut (L) to secure clamp (K)
to bracket (A).
7.
Coat ends of hoses (M and N) with silicone
compound (Item 32, Appendix D).
8.
Position hoses (M and N), tube (P), and
clamps (Q), removed as a unit, to mani-
fold (R) and cap assembly (D).
Using screwdriver, tighten clamps (Q) to
9.
secure hoses (M and N) to manifold (R)
and cap assembly (D).
10.
Close top deck grille doors (TM 5-5420-
202-10).
End of Task
8-16
Change 1