TM 5-5420-202-20.2
EXHAUST PIPE (RIGHT SIDE) REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
1.
Position packing (A) and clamp (B) onto pipe (C) and, using flat-tip screwdriver, tighten
screw on clamp (B) securing packing to pipe (C).
2.
Check insulation halves (D) and all attaching hardware for damage. Replace if necessary.
Position insulation halves (D) onto exhaust pipe (C).
3.
Using 5/16 inch wrench and cross-tip screwdriver, install 14 screws (E), each with two
4.
flat washers (F), lockwasher (G), and nut (H), to hold insulation halves (D) to
exhaust pipe (C).
Position new gasket (J) onto turbosupercharger
5.
housing (K).
Position exhaust pipe (C) with installed
6.
insulation halves (D) onto turbosupercharger
housing (K). Make sure exhaust port
(L) is pointing up.
7.
Using 9/16 inch socket and open end
wrench, install six nuts (M) securing
exhaust pipe to housing.
Go on to Sheet .4