TM 5-5420-202-20-3
MASTER CONTROL PANEL REPAIR (Sheet 64 of 73)
Master Control Panel Wiring Harness Replacement (Sheet 1 of 7)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOL:
3/8 in. combination box and open end wrench
Offset cross-tip screwdriver
Flat-tip screwdriver
3/8 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
11/32 in. open end wrench
SUPPLIES: Silicone compound (Item 32, Appendix D)
PRELIMINARY PROCEDURE: Remove panel from vehicle (page 10-34).
Using flat-tip screwdriver on screws (A)
and wrench on nuts (B), remove four
screws (A), lockwashers (C), and nuts
(B) securing connector (D) to panel
(E).
Remove connector (D) from panel (E) and
2.
position aside.
Using flat-tip screwdriver on screws (F)
3.
and wrench on nuts (H), remove four
screws (F), lockwashers (G), and nuts
(H) securing connector (J) to panel
(E).
Remove connector (J) from panel(E) and
4.
position aside.
Go on to Sheet 2
T A2 4 9 0 4 2