TM 5-5420-202-20-3
HIGH VOLTAGE IR POWER SUPPLY AND SHOCK MOUNT ASSEMBLY REPLACEMENT
(Sheet 4 of 6)
NOTE
Mounting hardware used to mount power supply to brackets
is the same for three ends of brackets shown. Mounting
hardware for hidden bracket is described in step 4 below.
INSTALLATION:
1.
Position mount (A) on outside
of bracket (B).
Insert two screws (C) through inside
2.
of bracket (B) and mount (A).
4.
Using 1/4 inch wrench to hold nut (E), use flat-tip screwdriver to tighten screw (C).
Using steps 1 through 4, install mounts (A) into each end of both brackets (B).
5.
G O on to Sheet 5
TA249096