TM 5-5420-202-20-3
RIGHT TAILLIGHT - STOPLIGHT ASSEMBLY REPLACEMENT (Sheet 1 of 3)
TOOLS:
9/16 in. combination box and open end wrench
Silicone compound (Item 32, Appendix D)
SUPPLIES:
1/2 in. masking tape (Item 58, Appendix D)
Pencil (Item 71, Appendix D)
Lockwashers (2 required)
Remove transmission shroud (page 9-2)
PRELIMINARY
PROCEDURES:
REMOVAL:
NOTE
Inspect leads (A) and leads (B) for
numbered tags (C) 23 and 24. If
leads do not have tags, use masking
tape and pencil to number leads.
1.
Reach through exhaust door opening and
using fingers disconnect two leads
(A) from hull connectors (B).
Slide two connector shells (D) back on
2.
taillight leads to expose two slotted
washers (E).
NOTE
Lubricant may be needed on leads
(A) to remove shells (D).
Remove two slotted washers (E) and two
3.
shells (D).
Go on to Sheet 2