TM 5-5420-202-20-3
ENGINE WIRING HARNESS REPLACEMENT (Sheet 8 of 12)
2. Place cable (B) in position on
starter (C) as shown.
3. Using flat-tip screwdriver, install
screw (D) securing cable (B) to
starter (C).
Place cable (E) in position on
starter solenoid (F).
5. Place two other cables (G) on starter
solenoid (F).
Using 3/4 inch wrench, install nut
and lockwasher (H).
Using spanner wrench, connect
connector (J) to low voltage
protection device (K).
8. Install two new cable ties (L)
around cables (B, E and G).
Place connector (M) to ignition unit (N).
Place cable (P) and clamp (Q) in
position.
Using 7/16 inch socket, install two
screws and lockwashers (R) securing
cable (P) and clamp (Q).
Place clamp (S) (hidden) in position over
cables.
Using 1/2 inch socket, install nut
securing cables and clamp (S).
TA249234
Go on to Sheet 9
10-293