TM 5-5420-202-20-3
BASKET/CONTROL PANEL ACCESSORIES HARNESS REPLACEMENT (Sheet 2 of 5)
1.
Using spanner wrench, remove
connector (A) to get to connector
(B) on master control panel.
2.
Using spanner wrench, remove
connector (B).
3.
Using socket, remove screw (C),
ground strap (D), nut (E), and
lockwasher (F) from bottom of
master control panel (G).
4.
Using socket and extension, remove screw
(H), clamp (J), ground straps (K) and (L).
and lockwasher (M) from center post
5.
Disconnect connector (P) (CKT
27) from lead to connector at
rear of gage indicator panel (Q)
(located just above master control
panel).
Go on to Sheet 3
Change 7
10-295-.37
6 35
