TM 5-5420-202-20-3
BASKET/CONTROL PANEL STARTING HARNESS REPLACEMENT (Sheet 4 of 5)
INSTALLATION:
Place harness assembly (A) in position
1.
behind straps (E) and through clamps
(H) as shown.
2.
Using 7/16 inch socket, install screws
(B), new lockwashers (C), and flat washers
(D) to secure straps (E) at three locations.
Using 7/16 inch socket, install screws (F)
3.
and flat washers (G) to secure clamps (H)
at six locations.
4.
Using 7/16 inch socket, install screws
(J) and new lockwashers (K) to secure
clamps (L) at vehicle floor and at purge
pump handle (M).
Go on to Sheet 5