TM 5-5420-202-20-3
BASKET WIRING HARNESS DISCONNECT (Sheet 4 of 4)
NOTE
The following instructions show
how to install the top wiring
connectors on the basket dis-
connect. Installation is the same
for all wiring harnesses.
NOTE
Check wiring diagram on sheet 3
for correct mating of connectors.
1.
Place connector (A) in proper position
with connector key at top on front side
of basket disconnect.
2.
Using flat-tip screwdriver, install four
screws and new lockwashers (B) securing
connector (A) to basket disconnect.
3.
Mate connector (C) onto connector
(A) at back side of basket disconnect.
4.
Using spanner wrench, tighten nut (D)
securing connector (C) on back side
of basket disconnect.
5.
Install other connectors as required
using the same procedure as steps 3
and 4.
6.
Connect three ground straps at batteries
End of Task
10-296.72
Change 7