TM 5-5420-202-20-3
SHIFTING CONTROL AND RELATED PARTS REPAIR AND REPLACEMENT (Sheet 5 of 14)
6.
Using 9/16 inch wrench, remove screw
(1), lockwasher (K), and washer (L) from
shaft (M).
7.
Remove top bracket assembly (N) from
shaft (M).
8.
Using finger, turn bearing (P) until alined
with slots in bearing race (Q).
Remove bearing (P) from race (Q).
9.
10.
Using hammer and 3/4 inch drift, drive
bearing race (Q) from bracket (R).
11.
Using hammer and 1/4 inch punch, drive
pin (S) out of link (T) and shaft (M).
12.
Using hammer and brass drift, tap link
(T) off shaft (M).
Go on to Sheet 6
TA249273
11-6