TM 5-5420-202-20-3
SHIFTING CONTROL AND RELATED PARTS REPAIR AND REPLACEMENT (Sheet 8 of 14)
ASSEMBLY:
Position fastener (A) thru control rod (B).
1.
Install nut (C) and lockwasher (D).
2.
Using 7/16 inch wrench, tighten nut (C).
3.
4.
Position bolt (E) through base assembly
(F) and install nut (G). Nut (G) will be
tightened when parking brake lever is in-
stalled.
5.
Using hammer and wooden block, tap bearing
(H) into base assembly (F). Bearing must
not extend beyond base assembly on either
side.
Go on to Sheet 9
TA249276
