TM 5-5420-202-20-3
SHIFTING CONTROL AND RELATED PARTS REPAIR AND REPLACEMENT (Sheet 6 of 14)
13.
Using hammer and 1/4 inch drive punch,
remove pin (U) from pivot (V).
14.
Remove control rod (W) from pivot (V).
Using flat-tip screwdriver, remove adjuster ( x ) ,
15.
spring (Y), and plunger (Z) from pivot (V).
16.
Using hammer and 1/4 inch punch, remove
pin (AA).
Using hammer and 1 inch brass drift, drive
17.
shaft (M) into base assembly (F) enough
to free pivot (V) and bearing (AB).
Remove bearing (AB), pivot (V), and shaft (M).
18.
INSPECTION:
Inspect pivot (V), adjuster (X), spring (Y), and
plunger (Z) for damage or wear. Replace as
required.
Go on to Sheet 7
TA249274