TM 5-5420-202-20-3
SHIFTING CONTROL AND RELATED PARTS REPAIR AND REPLACEMENT (Sheet 10 of 14)
Using vise, press bearing race (R) in bracket (S)
14.
flush with outer surface of bracket (S).
15.
Using fingers, place bearing (T) into slots
of race (R). Position as shown in illustration.
Using hammer and brass drift, tap link (U)
16.
into place on shaft (K).
Using hammer and 1/8 inch punch, install
17.
pin (V) through link (U) and shaft (K).
18.
Place bracket assembly (W) on shaft (K).
19.
Using 9/16 inch wrench, install screw (X),
lockwasher (Y), and washer (Z) on shaft (K).
TA249278
Go on to Sheet 11
11-11