TM 5-5420-202-20-3
SHIFTING CONTROL TO FORWARD INBOARD BELL CRANK ASSEMBLY ROD REPLACEMENT
(Sheet 2 of 5)
REMOVAL:
NOTE
Place shifting lever in R position. This will make bolts easier to take out by
moving tube forward.
1.
Using 9/16 inch wrench, remove two bolts (A).
2.
Remove rod (B).
3.
Using steel tape, measure center-to-center distance between holes in rod ends (C).
4.
Using pencil and paper, write down center-to-center distance.
TA249292
Go on to Sheet 3
11-26