TM 5-5420-202-20-3
THRUST WASHER BEARING SEAL (OUTPUT FLANGE) (SHEET 2 of 2)
INSTALLATION:
1. Lubricate oil seal (A) with
high-temperature grease.
2. Using hammer and
wooden block, tap seal (A)
into place.
3. Using brass drift,
insure seal (A) is seated
to the bottom of bore (B).
4. Aline -o- mark on
output flange (C) with -o-
mark on output shaft (D)
and install flange (C) on
shaft (D) to nearest spline.
5. Install washer (E) and
screw (F) on output shaft
Using socket and
(D).
torque wrench, tighten
screw (F) to 150 - 200 ft-
lbs(203-271 Nm).
6. Using pliers, install
nonelectrical wire (G) to
secure screw (F) to flange (C)
and trim excess.
End of Task
Change 2