TM 5-5420-202-20-3
NEUTRAL SHIFT SWITCH ADJUSTMENT (Sheet 3 of 3)
Lengthen screw (D) until meter just reads zero.
7.
Lengthen screw (D) by three complete turns.
8.
Using two wrenches, tighten jamnut (C)
9.
toward bracket (G) while holding screw (D).
10.
Set transmission lever to other positions;
meter should read zero in neutral "N" and
park "P" only. Replace neutral shift switch
(page 10-236) if any other readings are found.
Disconnect meter probes from electrical
11.
connectors.
12.
Connect connectors (A) and
(B) to (H) and (J).
Test adjustment by attempting to start
13.
engine in all transmission lever positions.
Engine should start only in neutral "N" and
park "P" positions.
14.
Install transmission shroud (page 9-6).
End of Task
TA249348
11-82