TM 5-5420-202-20-3
MASTER BRAKE CYLINDER MOUNTING BRACKET, TIE ROD, PUSH ROD, CLEVIS, AND
BOOT REPLACEMENT (Sheet 8 of 9)
6.
Position roller assembly (J) and two
washers (K) into clevis (A).
7.
Position bearings (L) above and below
clevis (A) into bearing cutouts on bracket
(H). Aline holes in parts (L), (A), (K),
(J), (K), (A), and (L) and insert pin (M).
8.
Using hammer and punch, install pin
(N) into bearing (L).
Using 7/16 inch socket, install screw
9.
(P), lockwasher (Q), and angle bracket
(R) to bracket assembly (H).
10.
Using 7/16 inch socket and 7/16 inch
wrench, install screw (S), nut (T),
lockwashers (U), and instruction plate (V) to
angle bracket (R).
Remove assembled bracket (H) from vise.
11.
Go on to Sheet 9
13-26