TM 5-5420-202-20-3
MASTER BRAKE CYLINDER MOUNTING BRACKET, TIE ROD, PUSH ROD, CLEVIS, AND
BOOT REPLACEMENT (Sheet 7 of 9)
INSTALLATION:
1.
Using vise with copper caps on vise
jaws, place clevis (A) in vise.
NOTE
Clevis (A) and nut (B) have left hand
threads. Nut (C) and push rod (E)
have right hand threads.
2.
Using 11/16 inch wrench, install nuts
(B) and (C) on tie rod (D) about 1-1/2
inches apart as shown.
NOTE
Nuts (B) and (C) will be tightened
during adjustment procedures.
3.
Using 5/8 inch wrench, assemble tie rod (D), push rod (E), and clevis (A).
4.
Apply adhesive to groove (F) on push rod (E). When adhesive becomes tacky to the touch,
install boot (G) with the drain hole in the lowest position.
5.
Remove clevis (A) and assembled parts (B), (C), (D), (E), and (G), from vise. Race bracket
(H) in vise. Install clevis (A) and assembled parts through hole in bracket as shown.
Go on to Sheet 8
TA249415