TM 5-5420-202-20-3
PARKING BRAKE CONTROL ASSEMBLY (ONE PIECE OR FRONT SECTION) AND LINKAGE REPLACEMENT
(Sheet 16 of 17)
NOTE
If installing one-piece control, omit next two steps. if installing front section of two-piece control,
do next two steps then go to step 42.
Using adjustable wrench to hold control assembly (A), use 7/8 inch wrench to tighten
31.
connector (AP) joining the two pieces of control assembly (A) together.
32. Using torque wrench and 7/8 inch crow-
foot, tighten connector (AP) on control
assembly (A) to 35-50 lb-in. (8.9 - 12.7
N.m).
Go to engine compartment.
33.
Using 15/16 inch wrench, install nut (AQ)
34.
onto control assembly (A).
35.
Install lockwasher (AR), bracket (AS), and
lockwasher (AT) onto control assembly (A).
36. Install nut (AU) onto control
assembly (A).
37. Using 15/16 inch crowfoot wrench and torque
wrench, tighten nut (AQ) to 45-50 lb-ft.
(61-68 N.m).
38.
Using 15/16 inch wrench, install brake control nut (AX) onto control assembly (A).
39. Using fingers, install brake control nut (AW) onto control assembly (A).
Using 15/16 inch crowfoot wrench and torque wrench, tighten nut (AW) to 25-30
40.
lb-ft. (34-41 N.m).
TA249489
Go on to Sheet 17
13-105