TM 5-5420-202-20-3
PARKING
BRAKE
CONTROL
ASSEMBLY
(ENGINE
COMPARTMENT)
REPLACEMENT
(Sheet
2
of
15)
REMOVAL:
NOTE
Replacement of left and right control assembly is the same,
except for location of clamps and routing of cable assemblies.
1.
Using 7/16 inch socket and 7/16 inch wrench, remove screw (A), washer (B), and nut
(C) holding clamp (D) to bracket (E).
2.
Using flat-tip screwdriver to pry open, remove clamp (D) from control assembly (F).
Using 3/4 inch socket with 10 inch extension, remove nut (G) and washer (H) from stud
3.
(J).
Remove bracket (E).
4.
5.
Using 3/4 inch socket, 10 inch extension, and universal joint remove nut (K) and washer
(L).
6.
Using flat-tip screwdriver to pry open, remove clamp (M) from stud (N) and control
assembly (F).
TA249492
Go on to Sheet 3