TM 5-5420-202-20-3
PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT (Sheet 9 of 15)
Position control assemblies (C and D) to transmission. Place ends with nuts (E) at brake
2.
housings.
Position control assemblies (C and D) through holes (F) in brake housings.
3.
4.
Install new preformed packing into nuts (G) before installing.
While inserting control assemblies (C and D), install, loosely the following parts in the following
5.
order: new packing with new retainer (H), nut with new packing (G), washer (J), spring
(K), and washer (L).
6.
Continue inserting control assemblies (C and D), guide ends of rods through brake lever
(M), and loosely install nuts (N) onto rod ends. It maybe necessary to compress springs (K)
to permit rod ends to pass through brake levers (M).
Go on to Sheet 10