fTM 5-5420-202-20-3
PARKING BRAKE CONTROL ASSEMBLY ENGINE COMPARTMENT) REPLACEMENT (Sheet 10 of 15)
Push packing with retainer (H) onto threaded
7.
sleeve of control assembly.
Thread nut (G) onto sleeve. Finger tighten
8.
nut (G).
Using 9/16 inch wrench on flats (B) of control
9.
assembly, use 15/16 inch wrench to tighten nut
(E) against housing.
Using fingers, thread nuts (N) onto rod end until a full thread is exposed below lower nut.
10.
Using 9/16 inch wrench tighten nuts (N).
11.
12. Push washer (J) and spring (K) downward and install new cotter pin through hole (P) in rod
end. Bend cotter pin with pliers to keep it from falling out.
13. Install cover (Q) with new gasket.
14. Using 7/16 inch socket, install eight nuts (R) with new lockwashers.
Go on to Sheet 11
TA249500