TM 5-5420-02-20-3
SHOCK ABSORBER REPLACEMENT (Sheet 2 of 2)
4.
While one person holds shock absorber (D),
second person, using hammer, drive out
upper grooved pin (F).
Remove shock absorber (D).
5.
INSTALLATION:
With one person holding shock absorber (A),
1.
aline upper eye (B) with hull mounting yoke (C)
and with keyways.
2.
Using fingers, insert upper grooved pin (D) in
position through yoke (C) and eye (B).
3.
Using pliers, install clip (E).
Aline lower shock absorber yoke (F), with
4.
roadwheel support arm (G). Aline keyways
by pushing up or pulling down on yoke.
5.
Using fingers, install lower grooved pin (H)
through shock absorber yoke (J), with cotter pin
hole facing out.
6.
Using pliers, install clip (K).
End of Task
TA249620