TM 5-5420-202-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 5 of 22)
12.
U s i n g 9/16 inch wrench, remove screw
(L).
R e m o v e steering rod end (K) from link
13.
assembly (M).
Position steering rod end (F) in clevis (G)
14.
and using 9/16 inch wrench, install screw
(E).
Using 9/16 inch socket and torque wrench,
15.
tighten screw (E) to 16 lb-ft (22 N.m).
16.
Using 9/16 inch wrench to hold steering
r o d end (K), use 9/16 inch wrench to
loosen jamnut (N).
17.
Using 9/16 inch wrench, turn steering rod
end (K) counterclockwise until screw (L)
will pass freely through link assembly (M)
and steering rod end (K).
18.
Using 9/16 inch wrench, install screw (L) through link assembly (M) and steering rod
end (K). Using torque wrench, tighten screw (L) to 16 lb-ft (22 N.m).
19.
Using 9/16 inch wrench to hold steering rod end (K), use 9/16 inch wrench to tighten
jamnut (N) and go on to step 27.
Go on to Sheet 6
TA249658
15-35