TM 5-5420-202-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 7 of 22)
NOTE
It may be necessary to manually move link assembly
before locating pin (P) can be inserted.
Insert locating pin (P).
28.
Check to see if driver's steering control is
29.
centered. If steering control is centered,
go on to step 52. If steering control is not
centered, go on to step 30.
U s i n g 9/16 inch wrench, remove screw
(Q).
31.
Remove steering rod end (R) from clevis
(S).
32.
Using 9/16 inch wrench to hold steering rod end (R), use 9/16 inch wrench to loosen
jamnut (T).
33.
Using 9/16 inch wrench, adjust length of control rod (U) by turning steering rod end
(R) clockwise or counterclockwise until screw (Q) will drop freely through clevis (S)
and steering rod end (R) when steering control is centered.
Go on to step 8.
TA249660
15-37